Replacing Seat Belts; Seat Belt Pre-Tensioners - MG MG6 Owner's Handbook Manual

Replacing Seat Belts

Always replace a seat belt assembly where the
webbing shows signs of fraying.
Regularly inspect the belt webbing for signs of fraying, cuts
and wear; also pay particular attention to the condition of
the fixing points and adjusters.

Seat Belt Pre-tensioners

The seat belt pre-tensioners will only
be activated once
BE REPLACED. Failure to replace the
pre-tensioners will reduce the efficiency of
the car's front restraint systems.
The seat belt pre-tensioners activate in conjunction with
the airbag to provide additional protection in the event of
a severe frontal impact. The pre-tensioners automatically
retract the seat belts. This reduces the forward movement
of the belt wearer in the event of a severe collision.
Note: The seat belt pre-tensioners will NOT be
activated by minor impacts.
*
and then MUST
SEATS AND RESTRAINTS
The seat belt pre-tensioners are located inside the front
seat belt reels.
The airbag warning light on the instrument panel will alert
the driver to any malfunction of the seat belt pretensioners
(see 'Airbag Warning Light and Messages').
If the pre-tensioners have been activated, the seat belts will
still function as restraints, and must be worn in the event
that the vehicle remains in a drivable condition.
IMPORTANT
• The removal or replacement of a pre-tensioner must
be carried out by the manufacturer trained, dealer
technicians.
• 10 years from the initial date of registration
(or installation date of a replacement seat belt
pre-tensioner), some components will need to be
replaced. The appropriate page of the Warranty and
Maintenance Manual must be signed and stamped
once the work has been completed.
4
95