Wpa-Psk/Wpa2-Psk; Figure 58 Wireless: Static Wep Encryption; Table 34 Wireless: Static Wep Encryption - ZyXEL Communications P-660HW-D User Manual

Figure 58 Wireless: Static WEP Encryption

The following table describes the wireless LAN security labels in this screen.

Table 34 Wireless: Static WEP Encryption

LABEL
Security Mode
Passphrase
WEP Key
Apply
Cancel
Advanced
Setup

7.4.3 WPA-PSK/WPA2-PSK

In order to configure and enable WPA(2)-PSK authentication; click Network > Wireless
LAN to display the General screen. Select WPA-PSK or WPA2-PSK from the Security
Mode list.
P-660HW-D User's Guide
DESCRIPTION
Choose Static WEP from the drop-down list box.
Enter a Passphrase (up to 32 printable characters) and clicking Generate. The
ZyXEL Device automatically generates a WEP key.
The WEP keys are used to encrypt data. Both the ZyXEL Device and the wireless
clients must use the same WEP key for data transmission.
If you want to manually set the WEP key, enter any 5, 13 or 29 characters (ASCII
string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-F") for a 64-bit, 128-bit or
256-bit WEP key respectively.
Click Apply to save your changes to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
Click Advanced Setup to display the Wireless Advanced Setup screen and edit
more details of your WLAN setup.
Chapter 7 Wireless LAN
107