Table of Contents
Advertisement
Figure 3 Front Panel
Power
The following table describes the LEDs and the WPS button.
Table 1 Front panel LEDs and WPS button
LED
STATUS
WPS Button
Press this button for 1 second to set up a wireless connection via WiFi Protected Setup
with another WPS-enabled client. You must press the WPS button on the client side within
120 seconds for a successful connection. See
page 38
Power
On
Off
WAN
On
Blinking
Off
Internet
On
Blinking
Off
WLAN 2.4/5G
On
Blinking
Off
LAN 1-4
On
Blinking
Off
WPS
On
Blinking
Off
Chapter 1 Introduction
Internet
WAN
WLAN 5G
LAN 1-4
DESCRIPTION
for more information on WPS.
The EMG3425-Q10A is receiving power and functioning properly.
The EMG3425-Q10A is not receiving power.
The EMG3425-Q10A's WAN connection is ready.
The EMG3425-Q10A is sending/receiving data through the WAN with a
1000Mbps transmission rate.
The WAN connection is not ready, or has failed.
The EMG3425-Q10A has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
connection is up.
The EMG3425-Q10A is sending or receiving IP traffic.
The EMG3425-Q10A does not have an IP connection.
The EMG3425-Q10A is ready, but is not sending/receiving data through the
5G wireless LAN.
The EMG3425-Q10A is sending/receiving data through the 5G wireless LAN.
The EMG3425-Q10A is negotiating a WPS connection with a wireless client.
The wireless LAN is not ready or has failed.
The EMG3425-Q10A's LAN connection is ready.
The EMG3425-Q10A is sending/receiving data through the LAN with a
1000Mbps transmission rate.
The LAN connection is not ready, or has failed.
WPS is enabled.
The EMG3425-Q10A is negotiating a WPS connection with a wireless client.
WPS is disabled.
EMG3425-Q10A User's Guide
16
WLAN 2.4G
USB 1-2
WPS
Section 1.6 on page 14
and
Section 6.2 on
Advertisement
Table of Contents
