Wpa-Psk/Wpa2-Psk - ZyXEL Communications LTE3301 Series User Manual

Table 20 Network > Wireless LAN > General: Static WEP (continued)
LABEL
Key 1 to Key 4
Apply
Cancel

7.3.3 WPA-PSK/WPA2-PSK

Select WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 37 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 21 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA-PSK
Compatible
Chapter 7 Wireless LAN
DESCRIPTION
The WEP keys are used to encrypt data. Both the LTE3301 and the wireless stations must
use the same WEP key for data transmission.
If you chose 64-bits, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bits, then enter 13 ASCII characters or 26 hexadecimal characters ("0-
9", "A-F").
You must configure at least one key, only one key can be activated at any one time. The
default key is key 1.
Click Apply to save your changes back to the LTE3301.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your LTE3301.
LTE3301 Series User's Guide
69