Leds - ZyXEL Communications EMG3425-Q10A User Manual

You can use the WPS button (
order to quickly set up a wireless network with strong security.
Make sure the power LED is on (not blinking).
1
Press the WPS button for more than three seconds and release it. Press the WPS button on another
2
WPS-enabled device within range of the EMG3425-Q10A.
Note: You must activate WPS on the EMG3425-Q10A and on another wireless device
within two minutes of each other.
For more information on using WPS, see

1.7 LEDs

Look at the LED lights on the front panel to determine the status of the EMG3425-Q10A. Use the
LED button on the rear panel of the device to turn the LED lights on or off. If you have already
pushed the LED button to the ON position but none of the LEDS are on, make sure the EMG3425-
Q10A is receiving power and the power is turned on.
Note: The Power LED will be on even if you push the LED button to the OFF position.
This is for you to determine whether the EMG3425-Q10A is powered on.
Figure 2 LED Button
Chapter 1 Introduction
) on the front panel of the EMG3425-Q10A to activate WPS in
Section 6.2 on page
LED button
EMG3425-Q10A User's Guide
15
38.