Table of Contents
Advertisement
Follow the steps below to configure the wireless settings on your EMG3425-Q10A.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Make sure the WIFI switch (at the back panel of the EMG3425-Q10A) is set to ON.
1
Open the Configuration > Network > Wireless LAN 2.4G > General screen in the AP's Web
2
Configurator.
Confirm that the wireless LAN is enabled on the EMG3425-Q10A.
3
Enter SSID_Example3 as the SSID and select Channel-06 as the channel. Set security mode to
4
WPA2-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click
Apply.
Chapter 6 Tutorials
EMG3425-Q10A User's Guide
41
Section 2.3 on page
19).
Advertisement
Table of Contents
