Machine Run Error Messages; Table 18. Machine Run Error Messages - Baum 2020 Instruction Manual

6.3 Machine Run Error Messages

Machine Run Error Messages help the operator to indicate a production problem.
ENGLISH GERMAN
Stop Stop1
Wrng Sht Fehlerbg
2 Sheet Doppelbg
No Feed Bog.Fehl
Feeder Sensor
Long Sht Bg.Lang
Knife 1 Schwert1
Knife 2 Schwert2
Knife 3 Schwert3
Snsor DN Stpl Ab
Snsor Up Stpl Auf

Table 18. Machine Run Error Messages

TP10243-3
CODES TYPE
Stop1 Information One of the stop buttons is depressed. ACTION: Make sure all
Stop2 Machine
Run Error
Stop3 Machine
Run Error
Stop4 Machine
Run Error
Stop5 Machine
Run Error
Stop6 Machine
Run Error
Stop7 Machine
Run Error
Stop 8 Machine
Run Error
Stop 9 Machine
Run Error
Stop 10 Machine
Run Error
Stop 11 Machine
Run Error
PAGE 36
DESCRIPTION
stop buttons are cleared and connectors X21, and X22 are
seated.
The Wrong Sheet Detector has been tripped. ACTION: Clear
the fault. NOTE: If the main drive was running, the error
condition will remain latched until the Drive START is pressed.
The Double Sheet Detector has been tripped. ACTION: Clear
the fault and check X22. NOTE: If sheet feed was active, the
error condition will remain latched until the Sheet Start is
pressed.
No paper detected within 40 cm of suction valve actuation,
while running in an automatic feed mode. ACTION: Check
misfeed, connector X14, and the condition of the count photo-
eye.
Photo-eye at suction valve is covered before Sheet Start is active.
The count photo-eye has been covered for more than 150% of
the user set sheet length distance. ACTION: Check misfeed,
connector X14, and the condition of the count eye.
The knife input 1 has been active for more than 1.5 times the
last measured time. ACTION: Clear the fault.
The knife input 2 has been active for more than 1.5 times the
last measured time. ACTION: Clear the fault.
The knife input 3 has been active for more than 1.5 times the
last measured time. ACTION: Clear the fault.
The Pile has been moving down for more than 2.5 seconds
while the unit is feeding paper. ACTION: Check Pile Sensor.
The Pile has been moving up for more than 1.5 seconds while
the unit is feeding paper. ACTION: Check Pile Sensor.