Table 1. Machine Setup Parameter List "A; Table 2. Machine Monitor Parameter List - Baum 2020 Instruction Manual

2.1.1 Machine Setup Parameters
Parameter
P00
P01
P02
P03
Table 1. Machine Setup Parameter List
P00: Input Factor
Each sheet sensed by the Sheet count sensor is multi-
plied by the Factor number and added to theTotal Input
Count, but does not effect the Batch Down Count, Number
of Batches or the Rate. The Factor can range from 1 to 24. If
the Input Factor is changed, it also changes the value of the
Output Factor to the same setting.
P01: Output Factor
This number is added to the Total Output Count but
does not effect the Batch Down Count, Number of Batches
and the Rate. The Factor can range from 1 to Input Factor
setting.
2.1.2 Machine Monitor Parameters
# Function
P10 Machine Speed
P11 Job Run Time
P12 Job Stop Time
P13 Job Make Ready Time
P14 Pause Time
P15 Job Number
P16 Employee's Number

Table 2. Machine Monitor Parameter List

P10: Machine Speed (Velocity)
This selection shows the machine speed in meters/
minute.
P11: Job Run Time
Displays the time duration this job has ran. Time
displayed in .01 Hours. This information becomes part of the
job record.
P12: Job Stop Time
Display the time duration this job has been interrupted.
Time displayed in .01 Hours. This information becomes part
of the job record.
P13: Job Make Ready Time
Displays the length of time that the Make Ready
feature was enabled. Time displayed in .01 Hours. This
information becomes part of the job record.
TP10243-3
Function Type
Input Factor Setup Variables
Output Factor Setup Variables
Tremat Setup Variables
Knife Setup Variables
Type
Process Variable
Process Variable
Process Variable
Process Variable
Process Variable
Process Variable
Process Variable
PAGE 24
Variable Displayed
Adjustable
Adjustable
Adjustable
Adjustable
P02: Tremat
This is an unavailable option.
P03: Knife
This is an unavailable option.
Variable
Based on input
Based on input
Based on input
Based on input
Based on input
Based on Input
Based on input
P14: Pause Time
Display the length of time that the Job was Paused.
Time displayed in .01 Hours. This information becomes part
of the job record.
P15: Job Number
A Job Number may be entered so that production
data may be recorded against it. This is an operator entry.
This information becomes part of the job record.
P16: Employee's Number
An Employee may be assigned a number. When
the employee operates the machine, his number may be
entered. This information becomes part of the job record.
1-24
1 to Input Factor
1 or 0
1 or 0
Displayed
Meters/Minute
Hours
Hours
Hours
Hours
Number 1 - 9999
1 - 255