Vii.) Installing Fold Plates & Stacker Delivery; Viii.) Operator Controls; Setting Folding Speed; Setting Stacker Belt Speed - Baum 2020 Instruction Manual

INSTALLING FOLD PLATES & STACKER
DELIVERY
Install the fold plates into the folder. When installing
the fold plates, take note of the symbol on the fold plate stop
(Figure 7-1). The swing deflector may only be brought
forward when the deflector symbol is also in the forward
position. Lock the fold plates in position with the clamp
levers (7-2). See "Fold Pan" section for fold plate setting
procedure.
Attach the delivery stacker (3-2) by hooking the hanger
brackets onto the round rods at the exit end of the folder.
Plug the stacker power cable into the corresponding outlet
on the main control enclosure on the pile feeder (Figure 6-
1).
Pull the handwheel (Figure 1-11) to manually turn the
fold rollers to be sure that they are operating smoothly.
Check for any foreign material, and be sure that the deflec-
tors do not touch the fold rollers.
1
2
Figure 7
1
5 6
4 7
3
8
2 9
1 10
BAUMFOLDER
CORPORA CORPORATION
Figure 8
+ + +
0
h
+
OPERATOR CONTROLS
The main operator control panel (Figure 8) is located at
the pile feeder. See the "Control Panel" section for a detailed
description of all the buttons.

1.0 Setting Folding Speed

The speed of the fold rollers may be set while the folder
is running! This is done by adjusting the speed control
potentiometer located on the top left side of the main control
panel. Clockwise rotation speeds the folder up; counter-
clockwise rotation slows the folder down.

1.1 Setting Stacker Belt Speed

An infinite speed range between high and low is set by
turning the control knob (Figure 9-1).

1.2 Emergency Stop Button

When an emergency stop button (8-1 & 9-2) is pressed,
the result is:
Sheet feed - stop
Folder drive - stop
Pile lift - stop
The pressure/vacuum pump continues to operate. The
emergency stop button must be pulled to release before the
machine can be restarted. An error message "StoP" will
appear on the readout.
The emergency stop buttons are found at the main
operator control panel (8-1) and the delivery control (9-2).
Figure 9
PAGE 21
1
2
TP10243-3