The Easy-Mode is used for folds that require half of the sheet length or less going into the
foldplate. These folding applications normally operate with a 1.0 Inch sheet gap. If you are folding
half of the sheet length or more into the foldplate you must have a greater gap.
TURN THE EASY-PARAMETER ON/OFF
1.
Press the
2.
. . . . . Press the
+ or - Buttons until P20 appears in the sheet gap display.
3.
Press the
display. You will now see the word "EASY" in the counter display
Batch Count + Button
in the counter display, see Figure E1.
Figure E1
TP10243-3
Machine Setup button
Sheet Gap
Batch Count + Button
until
P25
appears in the sheet gap display. You will now see the word "EASY"
PAGE 12
found in the top row.
until
P25
appears in the sheet gap