General Settings; Switch-On; Switch-On From Rear Panel; Switch-On From Front Panel - urmet domus DRV-065S-066S Quick Manual

1

GENERAL SETTINGS

Dear Customer,
Thank you for having purchased this Urmet product.
This document is just a quick user manual allowing you to install the Digital Video Recorders Urmet Domus S.p.A. models
1093/064S, 1093/065S and 1093/066S and to start using their main functions in a short time.
For more detailed information about the devices, refer to the full instruction manual inside the CD provided with the product.
1.1

SWITCH-ON

The device can be switched on in two ways.
¾ From the rear panel (device not powered – power LED off)
¾ From the front panel (device powered – red power LED on).
1.1.1

SWITCH-ON FROM REAR PANEL

Plug the power connector into the specific socket on the back of the unit and switch
The green power warning light on the front panel will light up. The welcome page will appear on the monitor.
The device initialisation processes will appear at this point.
The first row of icons represent DSP initialisation.
A red icon "X" means that errors occurred during initialisation. Contact the retailer or authorised installer.
The second row of icons represent hard disk initialisation.
SATA1, SATA2 icons, etc., appear.
A red icon "X" Means that the corresponding hard disk has either not been installed or has not been identified. Contact the retailer
or authorised installer.
eIMPORTANT NOTE
The green "READY" LED will light up on the front panel at the end of the initialisation operations.
1.1.2

SWITCH-ON FROM FRONT PANEL

Simply press on the front panel of the DVR when the power LED is red to power the device: the green power LED will light
up, the welcome page will appear followed by the device initialisation processes.
The DVR shows the connected video channels after it is switched on: this is called
In this mode, the DVR will not record and will not play recorded sequences back.
1.2

SWITCH-OFF

The dev ice can be switched o
¾

direct switch-off

¾

switch-off from main menu

Make sure that no recording or playba
1.2.1 DIRECT SWITCH-OFF
Hold button pressed for five seconds. A co
1.2.2 SWITCH-OFF FROM MAIN MENU
Press "MENU" to access the main menu. Select "UTILITIES by repeatedly pressing "
OFF" by repeatedly pressing " " and press "ENTER". Press again "ENTER" to confirm.
The power LED on the front panel of the DVR is red when the device is off and powered.
DS1093-024
Figure 18: welcome page
DSP INITIALISATION
HARD DISK INITIALISATION
ff in two ways.
ck is in progress before switching the unit off to prevent damage to the hard disk.
nfirmation dialog will appear. Press "ENTER" to confirm.
on the back of the unit to position 1.
"LIVE" mode.
" and press "ENTER". Select "SWITCH-
30