General Settings; Switch-On; Switch-Off; Direct Switch-Off - urmet domus 1093 Quick Manual

1

GENERAL SETTINGS

Dear Customer,
Thank you for having purchased this Urmet product.
This document is a simple, quick reference guide to help you access the main functions of the URMET Domus S.p.A. Digital
Video Recorder Ref. 1093/061SVN.
For more detailed information about the devices, refer to the full instruction manual inside the CD provided with the product.
1.1

SWITCH-ON

Plug the power connector into the specific socket on the back of the unit and switch
The green power warning light on the front panel will light up. The welcome page will appear on the monitor.
The device initialisation processes will appear at this point.
IMPORTANT NOTE
The device will output an acoustic signal if the hard disk is either not installed or not found. The alarm option can be deactivated
in the "Exceptions" menu.
1.2

SWITCH-OFF

The device can be switched off in two ways.

direct switch-off



switch-off from main menu


Make sure that no recording or playback is in progress before switching the unit off to prevent damage to the hard disk.
1.2.1 DIRECT SWITCH-OFF
Press the power button on the back..
1.2.2 SWITCH-OFF FROM MAIN MENU
Press "MENU" to access the main menu. Select "UTILITIES" and press "ENTER". Select "POWER OFF: START" and press
"ENTER". Press again "ENTER" to confirm.
1.3

REMOTE CONTROL ENABLE

The remote control must be enabled to control the device.
Enabling procedure
Press "DEV" on the remote control.

Enter the default address for controlling the DVR using the remote control: press "01" on the remote control.

Press "ENTER" on the remote control.

IMPORTANT NOTE

Define a different address for each device if several DVRs are installed, otherwise the remote control will control all
DVRs with the same address at the same time.

Press "DEV" on the remote control for deactivating the remote control: the green "STATUS" LED on the DVR will go
out.

You will need to repeat the remote control "enabling/addressing" operation whenever the device is rebooted.
1.4

MESSAGES ON THE MONITOR

The edges of the picture may not be completely visible on some "CRT" monitor models.
DS1093-029
Figure 21: welcome page
34
on the back of the unit to position 1.