Troubleshooting - Braun Omnitest 3 Manual

Troubleshooting

message
- 58 -
caused by
There is a problem with the
meter. There is an abnormal
Check Strip signal.
Error message could be
caused by a used or wet
test strip.
There is a problem with the
test strip.
Error message that indi-
cates that the blood or
control solution sample
was applied before the
symbol appeared on the
display.
what to do?
Repeat the Check Strip test
2 or 3 times.
Do not use the meter. Contact
B. Braun representative.
Repeat the test with a new
test strip. Apply a sufficient
amount of blood.
Test strip is damaged. Repeat
the test with a new test strip.
Repeat the test with new test
strip. Apply blood or control
solution only after the
symbol appears on the
display.