Split Spoke Feature; Re-Entering Similar Wheel After Split Spoke® Is Enabled - Hunter DSP9200 Series Operation Instructions Manual

4.10 Split Spoke
Re-entering Similar Wheel after Split Spoke® is Enabled
DSP9200 Series Balancer Operation Instructions
®
Feature
®
Split Spoke requires the optional inner Dataset
When in "mixed weight" or "adhesive weight modes," (dynamic or static), correction
weights can be hidden behind the spokes of a wheel.
Move the optional inner Dataset
pressing the foot pedal.
Move the optional inner Dataset
downward arm position. Enter the data by pressing the foot pedal.
The display is now flashing "SPO -1-." Without returning the optional inner Dataset
arm to the home position, rotate the wheel and place the arm so that it is centered
behind a spoke. Enter the data by pressing the foot pedal.
The display is now flashing "SPO -2-." Rotate the wheel to position the optional inner
®
Dataset arm behind an adjacent spoke (nearest spoke in either direction). Enter the
data by pressing the foot pedal.
Return the optional inner Dataset
Press the green
After wheel comes to a complete stop, raise the safety hood.
Place left plane weight (if in DYNAMIC mode) per the balance procedure being
performed.
Notice that there are two weights on the right plane bar graph. The amount shown
depends upon which weight is currently located at the correct position to place the
weight. If the wheel is not positioned to locate either weight, no amount is shown "---."
NOTE: There will be only one weight on the right plane if all of the
correction weight can be placed behind one spoke.
With the servo enabled, attach the adhesive weight behind the first spoke using the
weight amount shown.
Press the "Start" button with the hood raised to servo to the location for the second
spoke. The display automatically changes to the amount of the second weight.
Attach the adhesive weight behind the second spoke.
Verify by spinning again. Both planes should be zero.
®
Once Split Spoke mode is enabled, use the
orientation of the other three wheels from a set to avoid re-measuring the weight plane
dimensions each time.
Press the "Stop" button to disable servo and avoid starting servo aided weight
placement mode. Mount the next wheel.
Move the optional inner Dataset
downward arm position to align the spoke location.
Press the "Next" button. The display flashes "Put SPO."
Enter the spoke location by pressing the foot pedal (no need to enter a second spoke).
Return the optional inner Dataset
the green "Start" button if "Hood Autostart" is disabled. Continue the balancing
procedure.
®
®
arm to left weight plane position. Enter the data by
®
arm to the far right weight position, using the
®
arm to the home position. Close safety hood.
"Start" button if "Hood Autostart" is disabled.
®
arm to a position centered behind a spoke, using the
®
arm to the home position. Close safety hood. Press
arm.
"Next" button to input the spoke
4. Balancing Features and Options x 53
®