Measuring Wheel Width With Rim Width Calipers; Measuring The Inside Wheel Surface With The Pointer Disk Edge (Adhesive Tape-On Weights) - Hunter DSP9200 Series Operation Instructions Manual

Measuring Wheel Width with Rim Width Calipers

Measuring the Inside Wheel Surface with the Pointer Disk Edge
(Adhesive Tape-On Weights)
30 x 3. Balancing a Wheel
The rim width calipers are used to measure the distance between the wheel rim lips
(tire bead seats).
Apply the rim width calipers as shown below.
Read the scale imprinted on the rim width calipers and set the rim width knob to the
rim width reference number on the scale.
Place edge of manual Dataset
the location where the right edge
arm distance knob to the reference number on the Dataset
NOTE: The Dataset
photo below.
TIP:
When using Adhesive Weight programs, the greater the distance between the two
weights, the less weight it takes to perform a dynamic balance. The balancer
prevents the operator from locating the two wheel weights too close together to
provide a correct dynamic balance.
®
arm disk against the inside surface of the wheel at
of the adhesive weight is to be placed. Set Dataset
®
arm is used in the position as shown in the
DSP9200 Series Balancer Operation Instructions
®
arm scale.
®