Measuring The Wheel At The Inner Rim Lip (Clip-On Weight) - Hunter DSP9200 Series Operation Instructions Manual

Measuring the Wheel at the Inner Rim Lip (Clip-On Weight)

DSP9200 Series Balancer Operation Instructions
The diameter knob (3) is used to input the weight circle diameter of a weight plane.
CLIP ON WEIGHT
The optional inner auto Dataset
and diameter. Refer to "Measuring the Wheel with Inner and Outer Auto Dataset
Arm(s)," page 26.
The optional outer auto Dataset
width. Refer to "Measuring the Wheel with Inner and Outer Auto Dataset
page 26.
Measure the distance to the wheel inner rim lip by pulling the sliding Dataset
pointer outward until it is touching the wheel inner rim lip. Read the Dataset
scale and set the distance knob to the reference number on the scale.
Most of the time, the Dataset
illustration (A) below. In some cases, the rim lip may be so wide that the pointer disk
touches the rim as shown in illustration (B) below. In either case, the balancer will
compensate for this and provide accurate weight locations.
DATASET £ ARM
POINTER DISK
"P195/75R-14"
ADHESIVE WEIGHT
®
arm can be used to automatically measure distance
®
arm can be used to automatically measure wheel
®
arm pointer will contact the rim lip as shown in
TIRE
WHEEL
RIM LIP
®
®
Arm(s),"
®
arm
®
arm
3. Balancing a Wheel x 29