Getting Started; Introduction; References; For Your Safety - Hunter DSP9200 Series Operation Instructions Manual

1.1 Introduction

References

1.2 For Your Safety

Hazard Definitions

DSP9200 Series Balancer Operation Instructions

1. GETTING STARTED

This manual provides operation instructions and information required to operate the
DSP9200 Wheel Balancer. Read and become familiar with the contents of this
manual prior to operating the DSP9200.
The owner of the DSP9200 is solely responsible for arranging technical training. The
DSP9200 is to be operated only by a qualified, trained technician. Maintaining
records of personnel trained is solely the responsibility of the owner and
management.
This manual assumes that you are already familiar with the basics of tire balancing.
The first section provides the basic information needed to operate the DSP9200. The
following sections contain detailed information about equipment operation and
procedures. "Italics" are used to refer to specific parts of this manual that provide
additional information or explanation. For example, Refer to "Equipment
Components," page 9. These references should be read for additional information to
the instructions being presented.
Watch for these symbols:
CAUTION: Hazards or unsafe practices, which could result in minor
personal injury or product or property damage.
WARNING: Hazards or unsafe practices, which could result in
severe personal injury or death.
DANGER: Immediate hazards, which will result in severe personal
injury or death.
These symbols identify situations that could be detrimental to your safety and/or
cause equipment damage.
1. Getting Started x 1