Patch Balance Procedures; Static Patch Balance (Single Weighted Balance Patch) - Hunter DSP9200 Series Operation Instructions Manual

3.11 Patch Balance
Static Patch Balance
44 x 3. Balancing a Wheel
®
Procedures
®
Use Patch Balance procedure when weighted balance patches are to be cemented
to the inside of the tire. Weight balance patches are recommended for oversize light
truck tires that require excessive weight on the rim.
Before performing Patch Balance
and spin steps to determine which patch balancing procedure should be used:
Find TDC for the left plane.
If the right plane weight position indicator is lit solid and not blinking,
perform a Static Patch Balance.
If the right plane weight position indicator is blinking, perform a Dynamic
Patch Balance.
®
(Single Weighted Balance Patch)
A weighted balance patch will be placed in the center of the tread area inside of the
tire as shown below:
Mount wheel.
Enter Standard wheel dimensions.
Press the "Static/Dynamic" button to select STATIC mode.
Press the "Standard/ALU" button twice to select adhesive weight mode.
Measure inside tire diameter using a tape measure or tool, 221-527-1, just below
tread depth as shown below:
®
procedure, perform Standard Dynamic rim entry
SINGLE PLANE
DSP9200 Series Balancer Operation Instructions