Dynamic Patch Balance (Two Weighted Balance Patches) - Hunter DSP9200 Series Operation Instructions Manual

Dynamic Patch Balance
DSP9200 Series Balancer Operation Instructions
Enter inside tire diameter using the diameter knob.
Close safety hood and spin wheel.
After wheel stops, raise the safety hood.
Rotate wheel to TDC and mark tire and wheel for weighted patch(es) at location as
shown below:
If necessary, use
Weight£" to split weight.
Remove wheel from balancer and dismount tire from wheel.
Install weighted balance patch centered on inside of tire at mark as instructed by
manufacturer's instructions.
Mount the tire onto wheel and align marks.
Press the "Standard/ALU" button twice to select standard clip-on weight mode.
Balance. Verify balance condition by spinning again.
NOTE: Weight digits blink if the force signals are larger than the
measurement range of the balancer. If this occurs, check for
wheel being not properly centered on spindle shaft. If wheel
is centered, apply the displayed weights. The blinking
weights indicate that a second spin and additional weight(s)
may be required to get zero imbalance. Refer to "Correcting
Large Imbalances," page 52.
®
Weighted balance patches will be placed on the inside of the tire at the edge of the
tread area beside the sidewall as shown below:
LEFT PLANE
NOTE: Weighted balance patches should be installed only in tread
area. Do not install weighted balance patches near sidewall
or shoulder of tire.
Mount wheel.
®
"Left Plane Split Weight
(Two Weighted Balance Patches)
" or "Right Plane Split
RIGHT PLANE
3. Balancing a Wheel x 45