Using the Pressure Ring and Spacers
Pressure Ring
Spacers
24 x 3. Balancing a Wheel
The pressure ring clips on to the wing nut. It is used in lieu of the clamping cup.
It may also be used in place of a clamping cup if space is limited between the wheel
and the end of the spindle.
The pressure ring should be used to prevent the wing nut from directly contacting an
adaptor or a cone. It will act as a bearing to enable higher clamping forces.
There are two types of spacers:
x Hub Ring Spacers
x Shaft Spacers
Hub Ring Spacers
These light truck spacers are designed to build a larger pocket when using extra
large truck cones. It also provides a location for the centering pins found on some
dual wheel configurations.
DSP9200 Series Balancer Operation Instructions