Table of Contents
Advertisement
Chapter 25: LLDP
Enabling or
Disabling LLDP
352
To enable or disable the LLDP feature, perform the following procedure:
1. From the main menu on the left side of the page, click the LLDP folder.
The LLDP folder expands.
2. From the LLDP folder, select LLDP Global Settings.
A partial view of the AT-FS750 LLDP Global Settings Page is
displayed. See Figure 122 on page 351.
3. For the LLDP parameter, select one of the following radio button
choices:
Enabled: The LLDP feature is active.
Disabled: The LLDP feature is inactive.
Note
The LLDP feature is not dependent on the DHCP feature. As a
result, the DHCP feature can be set to either Enabled or Disabled
without affecting LLDP.
4. Click the Apply button to the right of the either the Enabled or
Disabled radio buttons.
The LLDP setting that you have selected is now active.
5. Below the Enable or Disable radio buttons, you may adjust the
following parameters as needed, then click the Apply button in the
area of these parameters:
Message TX Hold Multiplier: Sets the hold multiplier value. The hold
time multiplier is multiplied by the transmit interval to give the Time To
Live (TTL) that the switch advertises to the neighbors. The range is
from 2 to 10.
Message TX Interval: Sets the transmit interval, which is the interval
between regular transmissions of LLDP advertisements. The range is
from 1 to 10 seconds.
LLDP Reinit Delay: Sets the reinitialization delay, which is the number
of seconds that must elapse after LLDP is disabled on a port before it
can be reinitialized. The range is from 1 to 10 seconds.
LLDP TX Delay: Sets the value of the transmission delay timer, which
is the minimum time interval between transmissions of LLDP
advertisements due to a change in LLDP local information. The range
is from 1 to 8192 seconds.
Hide quick links:
Advertisement
Table of Contents
