Tagged Vlan Port Settings; Figure 59. At-Fs750 Vlan Port Settings Page - Allied Telesis AT-FS750/20 User Manual

Chapter 13: Virtual LANs

Tagged VLAN Port Settings

188
To configure a VLAN port that is a member of a Tagged VLAN, perform
the following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select VLAN.
The VLAN folder expands.
3. From the VLAN folder, select Port Settings.
The AT-FS750 VLAN Port Settings Page is displayed. See Figure 59
for a partial view of this page.

Figure 59. AT-FS750 VLAN Port Settings Page

4. For a selected port, set the PVID field to an existing VLAN ID.
For an explanation of the PVID parameter, see "Port VLAN Identifier
(PVID)" on page 178.
5. Set the Acceptable Frame Types to one of the following choices from
the pull-down menu:
All - This selection allows all incoming ingress frames presented to the
port to enter the switch.
Tagged - This selection allows only tagged frames presented to the
port to enter the switch. Untagged frames are discarded at ingress.