How To Remove The Turntable Rotation Hydraulic Motor - Genie S-80 Service And Repair Manual

October 2016
When installing the drive hub assembly:
6 Install the drive hub. Apply removable thread
locking compound to fastener threads.Torque
the backlash pivot plate mounting fasteners to
specification. Refer to Specifications, Machine
Torque Specifications.
7 Install the brake and then the motor onto the
drive hub. Apply removable thread locking
compound to fastener threads.Torque the
motor/brake mounting fasteners to
specification. Refer to Specifications, Machine
Torque Specifications.
8 Adjust turntable rotation gear backlash. Refer
to Repair Procedure, How to Adjust the
Turntable Rotation Gear Backlash.
Part No. 1269074
Turntable Rotation Components
How to R emove the Tur ntabl e R otation H ydr aulic M otor
How to Remove the Turntable
Rotation Hydraulic Motor
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Secure the turntable from rotating with the
turntable rotation lock pin.
2 Tag, disconnect and plug the hydraulic hoses
from the drive motor. Cap the fittings on the
motor.
3 Remove the hydraulic tube that connects from
the counterbalance manifold to the brake. Cap
the fittings on the brake and manifold.
4 Remove the motor/brake mounting fasteners.
Carefully remove the motor from the brake.
S-80 • S-85 • S-80X
Service and Repair Manual
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
79