Turntable Rotation Components; Rotation Hydraulic Motor; How To Remove The Turntable Rotation Motor - Genie Z-34 Service And Repair Manual

September 2015
Turntable Rot ation Co mpon ents
11- 1 R otation H ydr aulic M otor
11-1

Rotation Hydraulic Motor

How to Remove the Turntable How to R emove the Tur ntabl e R otation M otor
Rotation Motor
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Do not allow the turntable to rotate until the
hydraulic motor is installed.
1 Tag, disconnect and plug the hydraulic hoses
from the turntable rotation motor. Cap the
fittings on the motor.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
2 Remove the turntable rotation motor mounting
bolts. Remove the motor from the machine.
Part No. 1268515

Turntable Rotation Components

Z-34/22 Bi-Energy
Service and Repair Manual
59