Fault Codes; Section 4 Fault Codes - Genie S-80 Service And Repair Manual

October 2016
Section 4 Faul t Codes
Observe and Obey:

Troubleshooting and repair procedures shall be
completed by a person trained and qualified on
the repair of this machine

Immediately tag and remove from service a
damaged or malfunctioning machine.

Repair any machine damage or malfunction
before operating the machine.

Unless otherwise specified, perform each
procedure with the machine in the following
configuration:
• Machine parked on a firm, level surface
• Key switch in the off position with the key
removed
• The red Emergency Stop button in the off
position at both the ground and platform
controls
• Wheels chocked
• All external AC power supply disconnected
from the machine
• Boom in the stowed position
• Turntable secured with the turntable rotation
lock
• Welder disconnected from the machine (if
equipped with the weld cable to platform
option)
Part No. 1269074
Before Troubleshooting:

Read, understand and obey the safety rules
and operating instructions in the appropriate
operator's manual on your machine.

Be sure that all necessary tools and test
equipment are available and ready for use.

Read each appropriate fault code thoroughly.
Attempting short cuts may produce hazardous
conditions.

Be aware of the following hazards and follow
generally accepted safe workshop practices.
Note: Two persons will be required to safely
perform some troubleshooting procedures.
S-80 • S-85 • S-80X
Service and Repair Manual

Fault Codes

Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
89