Genie S-80 Service And Repair Manual page 97

October 2016
3 Push the backlash pivot plate towards the
turntable as far as possible (this will push the
rotation gear into the turntable bearing ring
gear).
4 Loosen the lock nut on the adjustment bolt.
5 Turn the adjustment bolt clockwise until it
contacts the backlash pivot plate.
6 Turn the adjustment bolt one half turn
counterclockwise. Tighten the lock nut on the
adjustment bolt.
7 Rotate the backlash pivot plate away from the
turntable until it contacts the adjustment bolt.
Then torque the mounting fasteners on the
backlash pivot plate. Refer to Specifications,
Machine Torque Specifications.
8 Rotate the turntable through an entire rotation.
Check for tight spots that could cause binding.
Readjust if necessary.
Part No. 1269074
Turntable Rotation Components
S-80 • S-85 • S-80X
Service and Repair Manual
81