Manually Rebuilding Array - HIKVISION DS-7104HGHI-SH User Manual

If there is no hot spare disk after rebuilding, it is recommended to install a HDD into the device and set is as a hot
spare disk to ensure the high security and reliability of the array.

13.2.5 Manually Rebuilding Array

Purpose:
If you do not enable the Auto-rebuild in Firmware Settings interface (Menu>HDD>RAID>Firmware) or the hot
spare disk has not been configured, then you can rebuild the array manually to restore the array when the virtual disk
is in Degraded status.
Steps:
1. Enter the Array Settings interface. The disk 3 is lost.
Menu > HDD > RAID > Array
2. Click Array tab to back to the Array Settings interface and click
At least one available physical disk should exist for rebuilding the array.
3. Select the available physical disk and click OK button to confirm to rebuild the array.
4. The "Do not unplug the physical disk when it is under rebuilding" message box pops up. Click OK button to
Digital Video Recorder User Manual
Figure 13. 12 Array Settings Interface
Figure 13. 13 Array Settings Interface
Figure 13. 14 Rebuild Array Interface
197
to configure the array rebuild.