Configuring General Settings - HIKVISION DS-7104HGHI-SH User Manual

11.1 Configuring General Settings

Purpose:
Network settings must be properly configured before you operate DVR over network.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
1 self-adaptive 10M/100M
DS-7204/7208HQHI-E1/E2;
DS-8100HQHI&HGHI-SH and DS-9000HQHI-SH series, with three working modes configurable:
multi-address, load balance, network fault tolerance; and 1 self-adaptive 10M/100M/1000M network interface for
other models.
2. Select the General tab.
3. In the General Settings interface, you can configure the following settings: Working mode (applicable for
DS-8100/9000 only), NIC Type, IPv4 Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can check the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.
The valid value of MTU is from 500 to 1500.
4. After having configured the general settings, click the Apply button to save the settings.
Digital Video Recorder User Manual
DS-8100/9000-SH
DS-7100 and DS-7200HGHI
Figure 11. 1 Network Settings Interface
network interface
2 self-adaptive
156
for DS-7100, DS-7204/7208HGHI-SH
10M/100M/1000M network
and
interfaces for