Self-Propelling Unit - Norton C1316 Owner's Manual

F. Self-Propelling System
Ignition
Ignicion
Throttle
Acelerador
Engine
Throttle
Speed Control Lever:
The operator's right hand lever is the speed control lever. Pushing the
lever slowly forward will increase the forward speed of the saw. Pulling it
to the center will place the saw in neutral. Pulling the saw to the rear of
the console (from the neutral) will increase the reverse speed.
The Speed Control Cable may need adjustment over time due to cable
stretch. To adjust place the Speed Control:
1. With the machine running and the Transmission Engaged move the
Speed Control Lever unit the Neutral Position is found.
2. Turn the engine off and disconnect the number one cylinder's spark
plug.
3. Loosen the set screw that attaches the Speed Control Cable to the
Transmission Control Lever. For the location of the Transmission
Control Lever see item #20 in the exploded parts diagrams C13xx,
C20xx, & PC20xx Transmission on page 37. Do not move the
transmission control lever.
4. Reposition the Speed Control Lever so that the Speed Control Lever is
in the center of the slot. Do not move the transmission control
lever.
Raise
Levantar
3600 RPM
RPM/Hours (RPM/Horas)
Emergency
Stop
Paro de
Emergencia
Foward
Adelante
Reverse
Transmission
Reversa
Transmisión
Speed
Control Lever
27
Blade Speed Chart
Tabla de Velocidad
Del Disco
Eng Pulley Blade Shaft
Blade Dia Eng rpm
Lower
Diameter RPM
Diametro de Flecha Disco
Bajar Motor rpm Diámetro en
Disco RPM
Polea Motor
16" (406mm) 3,600 rpm 3.15" (80mm) 2,520 rpm
16" (406mm) 3,600 rpm 3.15" (80mm) 2,520 rpm
20" (508mm) 3,600 rpm 3.15" (80mm) 2,520 rpm
24" (609mm) 3,600 rpm 2.65" (67mm) 2,120 rpm
Transmission
Engage/Disengage Lever
Blade Shaft
Pulley Dia
Diámetro en
Polea de
Flecha Disco
4.5" (114mm)
4.5" (114mm)
4.5" (114mm)
4.5" (114mm)