Norton C1316 Owner's Manual page 16

Tank remove the Fuel Cap slowly, fill tank to approximately 1-½" below
the bottom of the Fuel Tank Neck and reattach the Fuel Cap. Do not over
fill the tank. Avoid fuel spills and contact with fuel. Only re-fuel in well
ventilated areas and way from sparks and open flames.
Transmission Engage/Disengage Lever:
Controls the Engagement and Disengagement of the Transmission. Push
down to Engage and pull up to disengage the transmission. Only operate
the Transmission Engage/Disengage Lever when the machine is NOT
moving. Operation of the Transmission Engage/Disengage Lever while
the machine is moving may damage the Rear Wheels. When the
Transmission Engage/Disengage Lever is in the Disengage position the
machine can be moved with out the engine running. NOTE: When
parking the saw, it should always be left in the Engaged position, Speed
Control Lever in the neutral position, the engine OFF, and perpendicular
(right angle) to the grade (hill).
Speed Control Lever:
Controls the forward and reverse speed of the Transmission. To increase
the forward speed push the lever forward with the engine running at full
speed and the Transmission engaged. To reverse move the Speed
Control Lever towards the rear of the machine. NOTE: The further
forward or reverse the Speed Control Lever is moved the faster the
machine will move in this direction. To place in a neutral speed condition
place the Speed Control Lever in the center. NOTE: Over time the
neutral position may change slightly due to cable stretch and mechanical
component wear. Either re-adjust the Transmission Control Cable
Linkage or move the Transmission Speed Control Lever to it's new
position.
Choke 20 HP ONLY:
Units with a 20 HP Engine (C2016, C2020, C2024, PC2016, PC2020, and
PC2024) are equipped with a remote mounted Engine Choke Control. To
operate the Choke pull the control lever out away from the machine and
then follow the instructions for starting the engine found in the Engine
manual. All 13 HP units are equipped with a Choke control attached to
the Engine below the Air Cleaner on the Operator's Right Hand Side.
16