Replacing An Optical Drive - Lenovo 3000 K100 Hardware Maintenance Manual

Replacng an optcal drve
drive.
5. To install the new drive into the blue bracket, flex the bracket, and align
the pins  through  on the bracket with the holes in the hard disk
drive. Do not touch the circuit board  on the bottom of the hard
disk drive.
6. Slide the new hard disk drive into the drive cage until it snaps into
position.
7. Connect the power and signal cables to the hard disk drive.
8. See the "Completing the FRU
To replace an optical drive
1. Remove the computer cover. See
2. Disconnect the signal and power cables from the rear of the optical
drive.
3. Press the release button and remove the optical drive out the front of
the computer.
Chapter 7. Replacing FRUs (tower computers)
replacement".
"Removing the cover" .