Lenovo 3000 K100 Hardware Maintenance Manual page 42

Hardware Maintenance Manual

Diagnostic Error Code
015-027-XXX
USB port Configuration/Setup error
015-032-XXX
USB port Device Controller failure
015-034-XXX
USB port buffer allocation failure
015-035-XXX
USB port Reset condition detected
015-036-XXX
USB port Register error
015-040-XXX
USB port IRQ failure
015-195-XXX
USB port Test aborted by user
015-196-XXX
USB port test halt, error threshold
exceeded
015-197-XXX
USB port test warning
015-198-XXX
USB port test aborted
FRU/Action
1. Flash the system. See
update procedures"
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See
"Flash update procedures"
3. Run memory test
4. System board
1. Remove USB device(s) and re-
test
2. System board
System board
1. Run setup and check for conflicts
2. Flash the system. See
update procedures"
3. System board
Information only
Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log
file
1. Make sure the component that
is called out is connected and/or
enabled. See "Using the Setup
Utility,"
2. Re-run test
3. Replace the component that is
called out in warning statement
4. Replace the component under
test
1. If a component is called out,
make sure it is connected and/or
enabled. See "Using the Setup
Utility,"
2. Flash the system and re-test. See
"Flash update procedures"
3. Go to "Undetermined problems"
"Flash
"Flash