Lenovo 3000 K100 Hardware Maintenance Manual page 39

Hide thumbs Also See for 3000 K100:
Table of Contents

Advertisement

Diagnostic Error Code
006-198-XXX
Diskette interface test aborted
006-199-XXX
Diskette interface test failed, cause
unknown
006-25X-XXX
Diskette interface Error
011-000-XXX
Serial port Interface Test Passed
011-001-XXX
Serial port Presence
011-002-XXX
011-003-XXX
Serial port Timeout/Parity error
011-013-XXX
011-014-XXX
Serial port Control Signal/Loopback
test failure
011-015-XXX
Serial port External Loopback failure
011-027-XXX
Serial port Configuration/Setup
error
011-03X-XXX
011-04X-XXX
Serial port failure
011-195-XXX
Serial port Test aborted by user
011-196-XXX
Serial port test halt, error threshold
exceeded
Chapter 6. Symptom-to-FRU Index
FRU/Action
1. If a component is called out,
make sure it is connected and/or
enabled
2. Flash the system and re-test. See
"Flash update procedures"
3. Go to
"Undetermined problems"
1. Go to
"Undetermined problems"
2. Flash the system and re-test
3. Replace component under
function test
1. Diskette drive cable
2. Diskette drive
3. System board
No action
1. Remove external serial device, if
present
2. Run setup, enable port
3. System board
System board
System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system. See
update procedures"
3. System board
System board
Information only
Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log
file
"Flash


Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents