メインブレードの 組立
35
Main blade assembly
ø5ドラッグボルト ................ 2
ø5 drag bolt
M4ナイロンナット .............. 2
M4 nylon nut
メインブレードのバランスを取ります。
Balance the main rotor blade.
軽い方にテープ、デカール等を巻きます。
Wrap a lighter main rotor blade with tracking tape or a decal
to bring it into balance with the heavier blade.
テールブレードの組立
36
Tail blade assembly
M3X16CS .............................. 2
M3ナイロンナット .............. 2
M3 nylon nut
注 意 Caution
テールブレード、及びテールブレードホルダー
の向きにご注意ください。
Note the directions of the tail blade and the
tail blade holder.
注 意 Caution
テールブレードは軽く動く程度に締め込んでく
ださい。
Fasten the tail blade in a way as to permit it
to move slightly.
軽い方にテープ等を巻く。
Wind tape at a lighter side.
メインブレード(別売)
Main blade (sold separately)
SSZブレードスペーサー3T
SSZ blade spacer 3T
WCカーボンテールブレードL=90(別売)
WC carbon tail blade L=90 (sold separately)
M3X16CS
39
39
M4ナイロンナット
M4 nylon nut
注: メインブレードは軽く動く様にネジを締め付けます。
Note: Tighten the 5 drag bolts and M4 nylon nuts so that the main
blades can move slightly.
ø5ドラッグボルト
ø5 drag bolt
ブレードホルダー
Blade holder
M3ナイロンナット
M3 nylon nut
M3ナイロンナット
M3 nylon nut