Operating Instructions
Reset System, Machine Initialization
2
If the cash register becomes blocked (due to a paper jam, maloperation, etc.), proceed as follows:
Warm start:
This cash register start up procedure should only be performed when the following key combinations prove unsuccessful:
Following key positions "REG", "X", "Z", "PRG".
•
CLEAR
•
CASH TOTAL
•
#NS
Procedure for a warm start:
•
Turn the key to "OFF"
•
Switch off the mains power supply to the cash register, wait for 2 minutes, then press and hold the
FEED key and, while doing so, switch on the mains power supply for the cash register.
•
"0 0 0 0 0 0 0 0 0 0" appears in the display.
•
Release the FEED key.
•
Turn the key from "OFF" to "REG", the display switches to 0,00 and the cash
register is ready to operate again.
•
The reset procedure is completed.
In the event of a WARM START, only the last maloperation is deleted, the programming is retained.
If the cause of the blockage cannot be cleared by means of a WARM START, a SYSTEM RESET must be initiated in
exceptional cases.
Following a SYSTEM RESET, all the data is deleted and the cash register is reset to its default settings.
Refer to the Programming Instructions.
Olympia
4.01 2007(Rev-A)
CM 840/842 Cash Register
Page 9
All Rights Reserved