Table of Contents
Advertisement
Sending Documents via Telephone Line
Manual Number Dialing
To dial the telephone number manually, follow the steps below.
1
2
MEMORY
Make sure that the MEMORY lamp is on.
If not, press
3
Enter a telephone number from the keypad.
Ex:
5 5 5 1 2 3 4
4
START
The document(s) begin to store into memory with a file
number.
Then starts dialing the telephone number immediately after
storing the first page. (See Note 3)
The remaining page(s) continue to store into memory.
(see Note 3)
Note:
1. If you need a special access number to get an outside line, dial it first then press
(represented by a "-") before dialing the full number.
Ex
: 9 PAUSE 5551234
2. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing, press
(represented by a "/").
The dialing mode will be changed from Pulse to Tone after dialing the digit "/".
Ex
: 9 PAUSE TONE 5551234
3. This feature is called "Quick Memory Transmission". If you wish to store All the document(s) into memory first
before transmitting, change the Fax Parameter No. 082 (QUICK MEMORY XMT) to "Invalid". (See page 74)
Set document(s) face down.
to set "On".
MEMORY
(see Note 1) (see Note 2)
ENTER STATION(S)
THEN PRESS START 00%
TEL. NO.
5551234
* STORE *
PAGES=001
* DIALING *
5551234
PAUSE
4
NO.001
01%
NO.002
to enter a pause
TONE
93
Advertisement
Table of Contents
