Table of Contents
Advertisement
Inbound Routing
Setting the Routing Parameters
The DX-2000 can route documents received from a G3 fax machine to email address(s) or to Internet Fax
machine(s) connected to a LAN as an email, as well as to other G3 fax machine(s) over the telephone line.
To use this feature, the Fax Parameter No. 152 "SUB-ADDRESS ROUTING" and/or No. 153 "TSI ROUTING"
must be set to "2:Valid".
No. 152 SUB-ADDRESS ROUTING: Set this parameter to perform an ITU-T sub-address query within its auto
dialer and to route the received document(s) to the corresponding stations email address(s) or telephone
number(s).
No. 153 TSI ROUTING: Set this parameter to perform a Numeric ID (TSI frame information) query within its auto
dialer and to route the received document(s) to the corresponding stations email address(s) or telephone
number(s).
No. 154 ROUTING HEADER FORMAT: Use this parameter to select the type of email header to be included in
the "From" field of each routed faxes. (Default setting is "1:Originator")
Originator : The originating fax machine's TSI will appear in the "From" field of the routed email.
Relay Station : The routing station's email address will appear in the "From" field of the routed email.
No. 155 PRINT ROUTED DOCUMENT : Set this parameter to select whether a received fax to be routed is
always printed on the DX-2000 or only when the routing operation fails.
To set the above Inbound Routing parameters, follow the steps below.
1
FUNCTION
2
4
3
1
4
1
for "INVALID"
or
for "VALID"
2
130
7
SET
5
2
SET
SET MODE
(1-6)
ENTER NO. OR
FAX PARAMETER(1-164)
NO.=
152 SUB-ADDR ROUTING
1:INVALID
152 SUB-ADDR ROUTING
1:INVALID
152 SUB-ADDR ROUTING
2:VALID
Advertisement
Table of Contents
