Table of Contents
Advertisement
Programming or Retrieving Parameters via Email
Deleting the Entire Auto Dialer
If you wish to delete the entire Auto Dialer data in the DX-2000, type the following command in the body of the
email message:
@command
delete
@end
This command can also be inserted before the @begin to @end block, to erase the entire Auto Dialer data first,
then reprogramming it with new data.
This method will also prevent the "Overwrite Warning Message" that is sent back from the DX-2000, when the
current Auto Dialer station is overwritten.
To erase the entire Auto Dialer data, type the following command in the "Subject" line of your email:
#set abbr(password)# :
where the password is the Remote Password programmed in the DX-2000's User
Parameters. Retrieve and backup the existing data onto your PC first by following the
procedures for Retrieving and Editing on pages 58 to 61.
2
55
Advertisement
Table of Contents
