Panasonic DVCPRO HD AJ-HD1800P Operating Instructions Manual page 85

Setup menus
<BASIC> (continued)
No./Item Description of setting
022 For selecting the format in which the tape is to
be played back.
PB FORMAT
0000 MANU
The format is determined by the setting selected
for setup menu item No.023 (FORMAT SEL).
0001 AUTO1
The unit follows the format recorded on the tape.
Whenever the format is changed during
playback, the playback format switches to others
according to the changed format.
0001 AUTO2
If the playback format does not change for 1
second or more after the SERVO lamp lights
when starting playback, the current playback
format is fixed. The fixed playback format is
retained as is even if the format recorded on the
tape is changed unless the playback mode is
released.
023 For selecting the format when "MANUAL" has
been selected as the setup menu item No.022
(PB FORMAT) setting.
FORMAT
If "AUTO" is selected as the setting, the format
SEL
when playback starts is selected, and when the
tape is played back, the format is automatically
detected and matched with the format of the
playback tape.
0000 HD-LP
The DVCPRO HD-LP format is selected, and the
setup menu item No.020 (SYS FORMAT) setting
is followed.
0001 HD-SP
The DVCPRO HD format is selected, and the
setup menu item No.020 (SYS FORMAT) setting
is followed.
0002 422
The DVCPRO50 (422) format is selected.
0003 411
The DVCPRO (411) format is selected.
0005 DV
The DV format is selected.
0006 DVCAM
The DVCAM format is selected.
For setting the field system frequency
1
030*
0000 59/23
HD
The 59.94/23.98 Hz frequency is set.
FREQUENCY
0001 60/24
The 60/24 Hz frequency is set.
<Notes>
The set field frequency is enabled only when
there is no input for the OUT REF settings. If
there are any corresponding inputs, the field
frequency coincides with the field frequency of
the input.
When the HD SDI output is output with 60 Hz/24
Hz, the SD SDI is output as NO SYNC, and the
analog composite is output in the White/Black
mode (burst off).
(continued)
No./Item Description of setting
2 Video output reference
031*
0000 AUTO
OUT REF
When the HD REF input signal is supplied, it is
used as the reference. If it is not supplied but the
SD REF input signal is supplied, the SD REF
signal serves as the reference instead.
If neither the HD REF nor SD REF input signal is
supplied, the HD serial signal serves as the
reference.
If none of the HD REF, SD REF and HD serial
signals are supplied, the internal sync signal
serves as the reference.
0001 INPUT
When the serial input signal is supplied, it is used
as the reference
0002 HD_REF
The signal which is input to the HD REF IN
connector is used as the reference.
0003 SD_REF
The signal which is input to the SD REF IN
connector is used as the reference.
0004 E-AUTO
In edit mode, the state is the same as set in
[INPUT]. In modes other than edit mode, the
state is the same as set in [AUTO].
<Note>
For details, refer to [ Playback reference signal
specifications for tape playback ] (page 45).
*1: When the 50 Hz mode, 25 Hz (HD, SD) mode, or 50 Hz (HD,
SD) mode is selected in System Menu No. 25 (SYSTEM
FREQ), this item is not displayed.
*2: When the 23/24 Hz mode is selected in System Menu No. 25
(SYSTEM FREQ), this item is not displayed.
*The underlining (__) denotes the factory setting mode.
.
85