Time Code And User Bits; Time Code; User Bits; Setting The Internal Time Code - Panasonic DVCPRO HD AJ-HD1800P Operating Instructions Manual

Time code and user bits

Time code

The time code is used when the time code signal generated
by the time code generator (time code signal generator) is to
be recorded on the tape, its values are to be read by the time
code reader (time code signal reader), and the absolute
position of the tape is to be displayed in increments of hours,
minutes, seconds and frames.
The time code is written in the sub-code area (data area) of
the helical track. This enables insert editing to be conducted
independently using the time code alone. In addition, the
VTR's playback speed can be read from the stop mode to
the slow motion playback up to high-speed playback
(approx. 50k normal speed or approx. 100k normal speed
when using a DVCPRO tape).
The time code values are indicated on the display and
superimposed display.
TCR 00 : 07 : 04 : 23
Hours Minutes Seconds Frames

User bits

The "user bits" refers to the 32-bit (8-digit) data frame among
the time code signals which has been released to users. It
enables operator numbers and other values to be recorded.
The alphanumerics which can be used for the user bits are
number 0 to 9 and letters A to F.
118

Setting the internal time code

1
Set the VTR to the stop mode.
2
Set TC/CTL on the <HOME> menu to TC.
F3
3
Set SOURCE on the <TC> menu to INT (for
F1
selecting the internal time code).
4
Setting RUN MD on the <TC> menu
F5
REC:
The time code advances simultaneously with the
recording.
FREE:
The time code advances, like time, irrespective of the
VTR operation.
5
Setting TCG MD on the <TC> menu
F3
REGEN :
The continuity of the underlying time code in place
prior to editing is maintained.
PRE :
The time code can be preset using the operation
panel controls or remote controller.
AUTO :
The time code is automatically switched to REGEN or
PRE depending on the VTR's operation mode: during
editing, REGEN is selected; at all other times, PRE is
selected.
6
Registering the TC preset values
Display the <HOME> menu.
<TC/UB>
Preset (in the preset enable status)
1 When among the number keys is pressed, the
T
TC display switches to TCG (UBG), and the TCG
value characters (all digits) are highlighted.
2 When is pressed again, one digit is
T
highlighted, and the change enable status is
established.
3 Input the desired value using the number keys.
The entire input value can be cleared by pressing
while holding down .
0 F
4 To input the letters used with the users bits, press
the same number key (toggle by tapping
F
or ) while holding down . To move from one
8
digit to another, turn the ADJ dial.
5 To enter the value, press the
6 When the display screen has been changed
during the input process or if the
been pressed, the change enable status is
released, and the setting is canceled.
<CTL>
Reset
Press (TC CLR).
F4
7
key.
ENT
C button has