General; Overview Of Indications - ABB PST30 Installation And Commissioning Manual

Stand by X
At start signal X
Ramp up X
TOR X X X X X
At stop signal X
Ramp down X
1) Only if Fieldbus control is selected
2) Only if Kick-start is selected
3) Only if by-pass is used
4) Only if by-pass is not used
1SFC132003M0201
Chapter 11 Trouble shooting

11:1 General

11:2 Overview of indications

Active when selected
- - X - - X X
- - X - X X X X X X X X
- - X - - X X X
- X X X
- - X - - X X X
- - X - - X X X
This chapter is a guide that can be used in case problems
should arise with the softstarter or the application.
The softstarter normally indicates a fault with LED Fault, and
the LCD displays what type of fault it is. When a protection is
activated it will be indicated with LED Protection and the LCD
displays what type of protection is active.
Faults not displayed in the softstarter can also be found in
this chapter.
This table shows in which state the different indications for
protections, faults, and warnings may show up.
Always active
- - - - X -
-
2
- - - X X
- - - X -
- - - X - X
- - - X -
Trouble shooting
Active when
selected
1
- - X - - - X X
1
X - X - - - X X
1
- X X - - X X X
1 3
- X X - X - X X X X
4 1 3
X X X - - X X
1
X X X - - - X X
Chapter 11
- -
- -
- -
- -
- -
179