Inputs - ABB PST30 Installation And Commissioning Manual

Chapter 7
Settings and configuration
Settings
Functional Settings
Figure 31: Inputs groups
104

7:2.4.6 Inputs

To set parameters related to the programmable inputs, enter
the Inputs group.
Start/Stop
First programmable input (In0)
Torque control
Select the required function for the input In0.
Protections
Press Store to save/activate the selected function.
One of the following functions can be selected:
Warnings
None
Reset
Faults
Enable
Inputs
Outputs
Analog Output
Jog
Fieldbus
DOL
Seq Start
Start2
FB-Dis
Press Store to save/activate the selected function.
Caution!
The motor may start unexpectedly if there is a start signal
present when doing any of the actions listed below.
• Switching from one type of control to another (fieldbus
• Re-programming of the programmable inputs
• Reset all Settings (programmable input set to Enable)
No specific function (not activated).
Reset of an event.
When In0=0 the softstarter stops immediately.
When In0=1 the softstarter is in normal
operation.
Overrides all other inputs, except
LOCAL CONTROL.
Performs a start ramp until command is
released, then the motor stops immediately.
Open/close of the by-pass contactor
(PSTB370...PSTB1050).
Only if Setting I
rating.
Start signal for 2nd parameter set-up.
Disable of the fieldbus communication. The
softstarter can be controlled by the hard wire
inputs instead.
control / hardwire control)
is equal or lower than AC-3
e
1SFC132003M0201