D-Link des-3010f User Manual page 43

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
1000BASE-T cable for connection between the Switch port and other device capable of a gigabit
connection. The master setting (1000M/Full_M) will allow the port to advertise capabilities related
to duplex, speed and physical layer type. The master setting will also determine the master and
slave relationship between the two connected physical layers. This relationship is necessary for
establishing the timing control between the two physical layers. The timing control is set on a
master physical layer by a local source. The slave setting (1000M/Full_S) uses loop timing, where
the timing comes form a data stream received from the master. If one connection is set for
1000M/Full_M, the other side of the connection must be set for 1000M/Full_S. Any other
configuration will result in a link down status for both ports.
Fiber optic ports are statically set and unchangeable at 1000Mbps in Full-Duplex. The user may
configure these ports to be Auto or 1000M/Full.
Flow Control Displays the flow control scheme used for the various port configurations. Ports configured for full-
duplex use 802.3x flow control, half-duplex ports use backpressure flow control, and Auto ports use
an automatic selection of the two. The default is Disabled.
Click Apply to implement the new settings on the Switch.
31