D-Link des-3010f User Manual page 137

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Parameter
From [ ] To [ ]
AdmCtrlDir
PortControl
TxPeriod
QuietPeriod
SuppTimeout
ServerTimeout
MaxReq
ReAuthPeriod
ReAuth
Click Apply to implement your configuration changes. To view configurations for the 802.1X Authenticator Settings on a port-
by-port basis, see the 802.1X Authenticator Settings table.
Description
Enter the port or ports to be set.
Sets the administrative-controlled direction to either in or both.
If in is selected, control is only exerted over incoming traffic through the port you
selected in the first field.
If both is selected, control is exerted over both incoming and outgoing traffic through
the controlled port selected in the first field.
This allows you to control the port authorization state.
Select forceAuthorized to disable 802.1X and cause the port to transition to the
authorized state without any authentication exchange required. This means the port
transmits and receives normal traffic without 802.1X-based authentication of the
client.
If forceUnauthorized is selected, the port will remain in the unauthorized state,
ignoring all attempts by the client to authenticate. The Switch cannot provide
authentication services to the client through the interface.
If Auto is selected, it will enable 802.1X and cause the port to begin in the
unauthorized state, allowing only EAPOL frames to be sent and received through the
port. The authentication process begins when the link state of the port transitions from
down to up, or when an EAPOL-start frame is received. The Switch then requests the
identity of the client and begins relaying authentication messages between the client
and the authentication server.
The default setting is Auto.
This sets the TxPeriod of time for the authenticator PAE state machine. This value
determines the period of an EAP Request/Identity packet transmitted to the client. The
default setting is 30 seconds.
This allows you to set the number of seconds that the Switch remains in the quiet
state following a failed authentication exchange with the client. The default setting is
60 seconds.
This value determines timeout conditions in the exchanges between the Authenticator
and the client. The default setting is 30 seconds.
This value determines timeout conditions in the exchanges between the Authenticator
and the authentication server. The default setting is 30 seconds.
The maximum number of times that the Switch will retransmit an EAP Request to the
client before it times out of the authentication sessions. The default setting is 2.
A constant that defines a nonzero number of seconds between periodic
reauthentication of the client. The default setting is 3600 seconds.
Determines whether regular reauthentication will take place on this port. The default
setting is Disabled.
125