Initializing Ports For Port Based 802.1X - D-Link des-3010f User Manual

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual

Initializing Ports for Port Based 802.1x

Existing 802.1x port and MAC settings are displayed and can be configured using the window below.
Click Security > 802.1X > Initialize Ports to view the following window:
This window allows you to initialize a port or group of ports. The Initialize Port Table in the bottom half of the window displays
the current status of the port(s).
This window displays the following information:
Parameter
From and To
Port
MAC Address
Auth PAE State
Backend State
Open Dir
Port Status
Figure 10- 18. Initialize Port window
Description
Select ports to be initialized.
A read only field indicating a port on the Switch.
The MAC address of the Switch connected to the corresponding port, if any.
The Authenticator PAE State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth or ForceUnauth.
The Backend Authentication State will display one of the following: Request, Response,
Success, Fail, Timeout, Idle or Initialize.
The Operational Controlled Directions are both and in.
The status of the controlled port can be Authorized or Unauthorized.
129