Battery Start; Ups Shutdown - Powerware 9 Prestige Series User Manual

Battery Start

This feature allows you to start the UPS without utility power. After
utility power has been unavailable for one minute, press and hold the
Output On button until the alarm beeps.
The UPS supplies power to your equipment and goes into Battery mode.
The
of battery capacity remaining to the UPS. This process should take about
15 seconds.

UPS Shutdown

Performing a UPS shutdown turns off the power to your protected
equipment. Confirm the equipment is prepared for a power-off before
shutting down the UPS. To perform a UPS shutdown:
Powerware 9 Prestige Series User's Guide (3000 VA)
®
NOTE Before using this feature, the UPS must have been powered by utility power at
least once.
indicator remains lit and the front panel displays the percentage
NOTE Do not perform a UPS shutdown if you want to use the Maintenance Bypass
feature on the optional PPDM (see the following section).
1. Press and hold the Output

ceases (approximately three seconds).
The indicator remains lit indicating Normal mode, load
offline.
2. Unplug or remove the utility power from the UPS.

The UPS enters Battery mode for several seconds. The
indicator turns off and the UPS shuts down.
3. When all LEDs are no longer illuminated on the UPS, switch
the circuit breaker to the OFF (O) position on each battery
cabinet.
:
www.powerware.com
Off button until the long beep
UPS Operation
45