Choosing The Data Units - Raymarine ST70+ Operating Manual

6
Applicability: The procedures on this card apply to all configurations of ST70+ Instruments and Pilot Controllers.
Use these instructions to choose the data units you want to use. You can choose from a
range of imperial and metric units. Data unit settings are applied to the whole system.
Procedure
1. Starting
With any operational page displayed, press
the Display Settings option.
OK
Press to show the Display Settings menu.
At the Display Settings menu, scroll to the Units option.
OK
Press to display the first Units summary page.
2. Select option
OK
Press again to display the second Units summary
page.
OK
Press to display the Select units menu.
3. Select units.
Scroll to the unit you want to change.
OK
Press to display the selection screen for the units you
have chosen.
4. Set units
Scroll to select the units you want, then.Press
the setting and return to the first Units summary page.
If you want to set up other units, repeat the Select option
and Select units procedures above.
Returning to normal operation
When you have finished setting the units and the Select
units menu is displayed:
1. Scroll to the Continue option.
OK
2. Press to return to your operational page.
ST70+ general information

Choosing the data units

MENU
, to display the Main Menu, then scroll to
Units summary
These are your current settings.
i
Select units
Select units to change, using <
i
or >.
OK
to save
Wind Speed Units
Select required units, using < or
i
>. CANCEL exits without saving.
Select Units
Select units to change, using <
i
or >.
Speed
Distance
Depth
Wind Speed
Heading
Flow Rate
Temperature
Press OK to continue
Wind Speed Units
Press OK to select
KTS
Press OK to accept
Continue
Press OK to select
KTS
NM
FT
KTS
M
G/H
°C