Raymarine ST70+ Operating Manual page 25

12
Card
Applicability: The procedures on this card apply to ST70+ Pilot Controllers used with Raymarine SeaTalk and SeaTalk
Introduction
Fishing patterns are available on POWER boats, to enable you to automatically navigate
over a preset course in Auto mode. The patterns available are demonstrated in icon form, as
follows:
Circle Zigzag Cloverleaf Spiral
On fishing boats, the autopilot automatically recognizes your two most often used patterns
over a period of time, and places these at the beginning of the menu
You can customize the fishing patterns to obtain the coverage you want. Refer to the ST70+
User Reference Manual for details of customizable parameters.
Procedure
To use a fishing pattern:
1. At the Pilot Controller keypad, press
Main Menu.
2. Scroll to the All patterns option and press
the All pattern menu.
3. Scroll to the pattern you want to use, and press
4. The Pattern settings screen is displayed, showing the
parameters currently set for the selected pattern. If you
want to change any of the parameters:
i. Select the parameter you want to change, then press
OK
to select the setup screen.
ii.Use the Rotary Control to set the value you want, then
OK
press to save the setting and return to the Pattern
settings screen.
iii.Repeat steps i and ii as necessary, for other parame-
ters.
5. When all parameters are set as required and with the
Pattern settings screen displayed, press
autopilot then steers the boat over the fishing pattern you
selected.
Returning to manual control
To return to manual steering at any time, press
Using autopilot fishing patterns
on POWER BOATS only. They do NOT apply to ST70+ Instruments.
Circle against
heading
MENU
ST70+ Pilot Controller
Pattern
Figure 8
search
to display the
All Patterns
OK
to display
OK
.
Radius
Adjust the pattern radius.
AUTO
. The
i
STANDBY
.
ng
autopilots
Box
180°turn
search
Circle
Press OK to select
150
meters
Press OK to accept