Setting Up Data Boxes - Raymarine ST70+ Operating Manual

ST70+ Pilot Controller
Setting up a Pilot Controller display
Selecting Pilot Controller page types
To change the type of view on your Pilot Controller screen, hold down
The next view in the sequence is then displayed.
You can also change the view by using the menu system.
To do this:.
MENU
1. Press to display the Main Menu.
2. Scroll to the Pilot View option, then press
the Pilot View menu.
3. Scroll to the view you want:
• Plain view,
• 2D view (Compass Rose view), or
• 3D view (Isometric view.)
OK
4. Press to confirm the selection.

Setting up data boxes

You can select which data appears in the data boxes in the 2D and 3D pilot views. To do this:
MENU
1. Press to display the Main Menu.
2. Scroll to Display Settings then press
Display Settings menu.
3. Scroll to Data Boxes then press
Boxes menu.
4. Scroll to the data box you want to set up (1, 2 or 3) then
OK
press to select the setup page for that box.
5. Scroll to the data you want in the data box. A list of avail-
able data for pilot Controllers is given on Card 22.
OK
6. Press to return to the Data Boxes menu, and repeat
steps 4 and 5 of the Setting up data boxes procedure for
each data box you want to set up.
Returning to operating page
To return to normal operation from the Data Boxes menu, press
OK,
to display
OK,
to display the
OK
to select the Data
Card
MENU
for 1 second.
Pilot View
//// ////
N N
//// ////
0. 0
//// ////
00 00 W W E E
//// ////
S
//// ////
2D View
i
Press OK to select
Data Boxes
3 3 1 1
Box 1
Select the data for box 1.
i
Press OK to select
Data Boxes
BTW
1 1
Select data to be shown.
i
Press CANCEL to exit without saving.
Press OK to accept
CANCEL
three times.
7
continued
2 2