Power On/Off; Power On; Power Off - ROHS QH-NVR User Manual

2.7 Power On/Off

2.7.1 Power On

Before turning on power, please make sure all the connection is good.
Step1: Plug in power.
Step2: Turn on the power switch in the rear panel.
Step3: NVR starts to boot, POWER indicator will display red.
By default, the setup Wizard will start once the NVR has loaded. It will walk you
through some of the more important settings of your NVR. If you do not wish to use the
Wizard at this time, click Exit button. You may also choose to use the Wizard at a later time
by leaving the "Startup Wizard" checkbox checked.
Notice: This series can only display menu on VGA monitor, BNC monitor or HDMI
monitor at the same time. After the device power on, if there is live image without
menu display, please check up whether other device has menu display firstly, or
long press ESC button to switch the output among BNC, HDMI and VGA.

2.7.2 Power Off

Proper startup and shutdown procedures are crucial to expanding the life of
your NVR.
User can power off the NVR by remote controller, front panel and mouse.
By remote controller:
Step1: Press the Power button on the remote controller to pop up Shut Down window.
Step2: Click OK, the unit will power off after a while.
Step3: Disconnect the power.
By front panel:
Step1: Press the Power button on the front panel to pop up Shut Down window.
Step2: Click OK, the unit will power off after a while.
Step3: Turn off the power switch on the rear panel.
Step4: Disconnect the power.
Network Video Recorder User Manual
13